Cat6 Gigabit Network Surge Protector
Model: A-GE-24V
The model is designed to protect high-speed communication network from lightning over-voltage, transient over-voltage and static discharge. The protector implements multi-level protection circuit with advanced manufacturing process, and has excellent performance on discharge current, limiting voltage, response time, stability and over-all reliability.
FEATURES:
Multi. Protection circuits, Gas-Tube+ TVS technology
Dual protection in Common module and different module
TVS array technology, low capacitance
Multi-Strike Capability
TECHNICAL PARAMETER:
Model
Electrical Parameter
Nominal voltage (Un) 24V
Max. continuous operating voltage Uc 30V
Nominal discharge current(8/20µs)In 2.5kA
Max. discharge current (8/20µs)Imax 5kA
Limiting voltage (10/700µs) Up
Line-line 60V
Line-ground 500V
Adapt transmission rate 1000Mbps
Insertion loss Ae 0.5dB
Protection line 1-8
Response time Ta 1ns
Interface form RJ45
Mechanical characteristics
Dimension 100(L) ×38(W) ×28(H)mm
Weight per unit 100g
IP Code IP20
Working conditions Temperature: -40 to 80ºC, Relative humidity: ≤95% Standards Compliance CE, FCC, RoHS, ISO9001
INSTALLATION AND MAINTENANCE
- The SPD should be connected in series between the protected device and the signal/power transmission channel.
- The input terminal (IN) of the SPD should connect to the signal/power transmission channel, and the output terminal (OUT) of the SPD should connect to the protected device.
- Connect earthing wire of the SPD to earthing bus-bar of the lightning protection system of the room or building.
No special duty needs to be carried out for maintenance. When problem arises and the SPD is suspected, check the system with SPD taken out of circuit. Should system recover, the SPD shall be regarded as a damaged unit and must be replaced immediately.